Fluorescent epoxy paint for floors, staircases, warehouses and ERP

FL2329 is a fluorescent epoxy paint designed to create highly visible marking zones on indoor floors and surfaces. It meets the needs of professionals looking for a paint that is bright, hard-wearing and durable.

It is recommended for garage floors, warehouses, factories, staircases, industrial premises, public access buildings and all high-traffic indoor areas.

Thanks to its fluorescent effect, FL2329 effectively highlights:

• obstacles;
• passages;
• hazardous areas;
• steps;
• traffic routes;
• storage areas;
• technical areas.

The colours available are: fluorescent yellow, fluorescent green, fluorescent red and fluorescent orange.

FL2329 is not just a decorative paint. It is a hard-wearing epoxy system, formulated to provide good surface hardness and resistance to wear, water and various common chemicals.

The product is supplied as three ready-to-mix components:

• A: resin – 1.125 kg
• B: hardener – 0.375 kg
• C: fluorescent pigment paste – 0.100 kg

The complete mixture corresponds to the following ratio:

9 parts of A + 3 parts of B + approximately 1 part of C

There are two possible methods: using the complete kit without weighing, or preparing the mixture whilst strictly adhering to the proportions. In all cases, the ratio of resin A to hardener B must never be altered.

The product must not be diluted with water. It is recommended that you mix only the quantity required for application within a short period. At 20°C, the pot life of the mixture is approximately 40 minutes. The higher the temperature, the shorter the pot life.

For a luminous finish, FL2329 must be applied to a white surface. On an untreated or dark background, the fluorescent effect will be much less intense.

It can be applied using an epoxy roller, a brush or an air-powered spray gun. Airless spray guns are not suitable.

Application :

• Apply in two coats of 150 to 200 g/m² per coat, leaving a 24-hour interval between each application.
• The recommended dry film thickness is approximately 330 µm.
• Coverage: approximately 10 m²/kg per coat.
• ► Download the technical data sheet available on this page for further information.

The coating can be recoated after approximately 24 hours. It takes 8 to 10 days to cure completely. Before this time has elapsed, avoid heavy use, hot tyres, greases, oils and household cleaning products.

FL2329 is for indoor use only. It is not suitable for outdoor applications exposed to UV light.